Amana tool AMS-213 3-Pc 90, 108 Degree and 1/4 Inch Diameter for Aluminum Composite Material (ACM) Panels, 1/4 Inch SHK Pack

Cost of Tools$201.60Selling Price$151.20% Saved25% Carbide tipped double edge folding 'V’ groove industrial router bits for shaping Aluminum Composite Materials (ACM) such as Alucobond, Dibond and other brands alike. Designed for scoring or cutting the following aluminum/plastic composite materials:AcetateAluminum, Brass, Bronze, Clay, Zinc & Wood Composite PanelsAluminum 5052Aluminium Composite Materials (ACM)Aluminium Composite Panel (ACP)*ALPOLIC Copper Composite Material (CCM)AlcubondAlupanelBakeliteDibondDurabond**e-panel™EtalbondNylonPE and FR CoresPhenolicsPlastic/AcrylicPlexiglasPVCTitanium Composite Material (TCM)WoodAluminum Composite Panel (ACP) is a type of ACM flat panel that consists of two thin aluminium sheets bonded to a non-aluminium core and is widely used as cladding for many diverse applications such as interior and exterior office buildings, external cladding or facades of buildings, hospitals, convention centers, airports, hotels, insulation and signage. **Durabond is a polyethylene core with 0.3mm colored aluminum sheet on either side, pre-finished requiring no decoration. Routing V-shaped grooves, whereby the aluminum cover and a part of the polyethylene core is removed, allows folding the remaining material by hand. Specially designed router bits are used to route V-grooves in the above materials to allow easy bending without cracking the bent area. Route within 0.8mm from the bottom of the composite panel to achieve a clean bend/radius. Routing V-shaped grooves, whereby the aluminum cover and a part of the polyethylene core is removed, allows folding the remaining material by hand. Ideal for wall panel fabrication. For use on routers and CNC machinesIndustrial quality, carbide tipped ACM panels may be used both indoors and outdoors. Ideal for wall panel fabricationRPM: 18,000-24,000 (*Feed rate should be 120 inches per minute.)Benefits of ZrN Coating:Optimized flute geometry and low Total Indicated Runout (TIR) guarantees clean cuts, essentially eliminates sanding and reduces chatter when used with low TIR spindlesCreates a harder and tougher cutting ceramic over carbide edge, allowing for a prolonged cutting edge life and helps to prevent the build-up/galling of material in the flutes while cuttingHas the ability to run and/or be spun much faster than uncoated toolsHigh aspect ratio for single pass deep-reach cuttingHigh flute volume supports high feed rates and chip loads.Flute geometry optimized for cutting sign foam, sign board, hardwoods, thermoplastics and phenolic composites