Amana tool DRB-424 Polycrystaline Diamond (PCD) Tipped Double Flute 1/2 D x 3/4 Inch CH x 1/2 SHK Straight Plunge Router Bit

2 Flute Diamond tipped for cutting composite panels and Fiberglass. Tool life is expected up to 25 times when compared with the carbide tip tooling. Diamond is the hardest material on the earth. Polycrystalline Diamond (PCD) tooling is manufactured in a high-temperature and high-pressure laboratory that fuses diamond particles onto a carbide substrate, which allows the diamond to be brazed onto a tool body. PCD Tooling Benefits: Harder cutting edge provides higher resistance to wearCut thousands of feet more than carbide without changing tool, saving setup timeOptimized machine tool efficiencyQuality of finish is often significantly improvedIf you’re looking for the ultimate in tooling, you’ve found it! Amana Tool's PCD tipped Straight Plunge router bits will cut a wide variety of tough, abrasive materials including composites, particle board, MDF (both raw or with melamine), plywood veneer and fiberglass. The cutting edge lasts much longer than carbide for extremely long life. Depending on the material being cut, PCD tooling has been known to out perform a carbide tool by a ratio of 300:1. However, to be conservative in your buying decision, we suggest you base your expectations on 25:1 ratio over carbide tooling. Excellent for cutting:AluminumAluminum Composite Material (ACM)Composite panelsCustom composite materialsFiberglassFiber-reinforced compositesFiber-reinforced urethaneFiber-reinforced structural foam floorsLaminateLightweight compositesMDFParticle boardPlywood Veneer