Questions
-
#24 federico gioja asks about ONSRUD 40-137 1/2" High Speed Steel Two Flute Upcut for Wood Sheet, Block and Plate Aluminum Router Bit
do you have any 3 flute 12mm diameter shank and cut, thanks.
-
#23 Judy Tryniecki asks about ONSRUD 70-502 HSS Plastic drill bit
I am attaching a grab bar to a 1933 era cast iron (I assume) on the top of the 'side' which is what is needed (tub and house have no resale value). It is the least expensive option (and doable). There is no solid wall along the other side (builder did shortcuts!). Thank you.
-
#22 Randyt McGinnis asks about Entity was deleted
What size material ?
-
#21 Tom asks about Whiteside 3110B SLOT & UNDERCUT BIT
I am looking for a slot cutter to go in a quarter inch router Collett that will cut a 5/32 kerf approximately half inch deep.It needs to be flush on outside with a bearing riding on the inside of the cutterhead
-
#20 Janis Hagan asks about FS Tool LH862 FINE CROSS-CUT
Does LF mean left hand? If so, then "lefties" should use them? LF862. Same specifications as LF860.
Thank you -
#19 Daniel Sahagun asks about ONSRUD 60-111MW 1/4" Solid Carbide One Flute Max Life Compression Bit for Double Sided Laminates & Veneers Router Bit
hello bought this bit have problem cutting 3/4 fire rated plywood the bits burn to fast cutting at 18000rpm df 125 cut feed at 250 can you help figure out speeds and feeds please
-
#18 ANDREW SANTILLI asks about 1-1/4 Bore Carbide Window Sash Cutter Set (4 Piece Cutter Set)
Where do infind the actual profile dimensions trying to match an existing profile on historical building
This would be for the 1-1/4 window sash cutters for spindle Shapers -
#17 Robert Curran asks about FREEBORN - MC-59-040 - CARBIDE FLOORING SET Shaper Cutter
What is the actual tongue thickness produced by these cutters
-
#16 Steward Crum asks about Amana tool 61292 Insert Carbide Spiral Jointing 62mm D x 80mm CH x 12 Teeth x 1-1/4 Bore Shaper Cutter
I have a 3/4" bore shaper. do you need a second set of reducing bushings for the rub collar as well or is there a 3/4" rub collar? Thanks
-
#15 Donald Jones asks about FREEBORN - PT-27-020 - T-ALLOY WINDOW SASH SET Shaper Cutter
How thick of a sash can be molded? I will have 1/2" insulated glass and need enough space for the glaze moulding